Any shaft recommendations for a Sonartec TRC 3 Wood? Just bought the head, and am looking for a good shaft to put in it. My 5 iron distance is 195, and I am a hitter. I plan on using it off the tee on tight par fours, and for reaching long par 5's. I hope to carry it at least 250.
The TRC is a great "hybrid" type club that has been discontinued. I think it is actually a far better performing and looking club than the Mid. I found success with an Aldila NV-95 "S" in my TRC. I also added a half inch to gain a few extra yards for par 5 reachability. So bottom line, I would stay with a slightly heavier graphite gram weight in the 85-95 zone and mid flex point. This would match the weight and characteristics of the TRC design. IMO
Originally Posted by jpgolf
The TRC is a great "hybrid" type club that has been discontinued. I think it is actually a far better performing and looking club than the Mid. I found success with an Aldila NV-95 "S" in my TRC. I also added a half inch to gain a few extra yards for par 5 reachability. So bottom line, I would stay with a slightly heavier graphite gram weight in the 85-95 zone and mid flex point. This would match the weight and characteristics of the TRC design. IMO
When you refer to the Mid is that the Md Transition club?
